Monolayer Graphene Film on 175um PET Substrate (25mm x 25mm)
MSE Supplies guarantees the high quality and best price on the market for our graphene products. Buying graphene products from MSE Supplies will save you ~50% or more compared to prices listed by other re-sellers such as Sigma-Aldrich and Cheap Tubes.
Monolayer Graphene on PET (10 mm x 10 mm) - Pack 4 units
Grown by CVD on copper foil and transferred to polyethylene terephthalate polymer (PET) using wet transfer process.
- · Transparency: > 97%
- · Coverage: > 95%
- · Thickness (theorical): 0.345 nm
- · FET Electron Mobility on Al2O3: 2000 cm2/Vs
- · FET Electron Mobility on SiO2/Si: 4000 cm2/Vs
- · Sheet Resistance: 580±50 Ohms/sq (1cm x 1cm)
- · Grain size: Up to 10 μm
- · Thickness: 175 µm
All our samples are subjected to a rigorous QC in order to ensure a high quality and reproducibility of the graphene.
- · Raman Spectroscopy: I(G)/I(2D)<0.5; I(D)/I(G)<0.05
- · Optical Microscopy inspection of each individual sample to ensure good transfer quality and purity
If your application requires more specific controls (AFM, SEM...) please do not hesitate to contact us.
Flexible displays, ITO replacement, Graphene research, OLEDs
“Flexible solid state lithium batteries based on graphene inks”
J. Mater. Chem., 2011,21, 9762-9767 doi: 10.1039/C1JM10826C
“Enabling Graphene Oxide Nanosheets as Water Separation Membranes”
Environ. Sci. Technol., 2013, 47 (8), pp 3715-3723; doi: 10.1021/es40057g
“Graphene Oxide for effective radionuclide removal”
Phys. Chem. Chem. Phys., 2013, 15, 2321-2327; doi: 10.1039/C2CP44593J
FREQUENTLY ASKED QUESTIONS
A: It has to be done in a dry way. Two alternatives: 1) Use a diamond pen to cleave it, but then you can have some debris on the graphene due to the Si wafer cleavage 2) In order to protect it from the debris, you can cleave it using a protective layer such as the PMMA on top of graphene. After cut it with a diamond pen remove the PMMA with solvents. In this case, we can provide you the sample with the PMMA already on top.
A: Usually additional cleaning process is not needed to obtain good electronics results using our graphene directly. If additional cleaning is needed a "thermal annealing" can be applied, typically at 350-400C under inert atmosphere for 30mins but this recipe depends on the annealing oven to be used.
A: The electron mobility values depend heavily on the method used to determine them but typical Hall mobility values for our graphene samples are around 2000-2700 cm^2/Vs with very good uniformity. These mobility values apply to your samples as well since they were manufactured using the same methods (recipe, transfer, etc.).
We Also Recommend